Skip to content

List for Supported Hardwares

Welcome to the Hardware List. To navigate through this section, use the sidebar on the right.

This page shows infomation on certain hardware that is supported by flowshutter. More and more manufacturers are adding support for new hardware and new feature based on that, so this list is not exhaustive and keeps growing.

NeutronRC SDB

NeutronRC Stabilization Data Box

General Overview

Specification

  • Bone-like shape, 43 x 18 x 10mm
  • Nylon sintered case with acrylic panel
  • Adjustable cold shoe mounts (for different mounting postions and/or orentations)
  • Built-in 600mah battery (enough for 5 hours of working)
  • Built-in power switch
  • Built-in battery charger and indicator
  • Built-in single track MEMS microphone
  • Dual layer design with flowbox built-in (F411 + BMI270 + 128MB blackbox)
  • Separate USB-C's of flight controller and flowshutter
  • Dual 3.5mm jack for camera controlling and audio injection

DIY (FC Sized)

This scheme was designed by us to take advantage of the old 30x30 size flight controller.

General Overview

Specification

  • FC shape, holes 30.5 x 30.5mm, size 38 x 40 mm
  • Bare PCB
  • 2-6s input voltage range (7.4V to 22.2V)
  • Dual buttons for each button IO
  • Solder pads for camera controlling and audio injection IOs
  • Easy to DIY

DIY (Credit Card Sized)

General Overview

Specification

  • Credit card shape, holes 47.6 x 28.3 mm, shape 50 x 32 mm
  • 18650 battery case support
  • On-board power switch
  • On-board battery charger and indicator
  • Solder pads for camera controlling and audio injection IOs
  • Easy to DIY